This is a 3d printed replica of the no-longer available Honda Part nr: 83640-149-610
FAQ
How is the part made?
The side covers are reproduced by FDM printing based on own 3D scan data from a NOS original.
Which material is used?
Mostly ASA. Some colors in ABS. No PLA! Click here to read more about the material properties >
Are the Layer lines visible? Do I need to sand the part?
Yes there are layer lines, this is an inherent part of the production process. However these lines are quite fine, thanks to a fine printing resolution of 0.16mm layer height.. That makes it easier to sand to a smooth surface. There can be some other small imperfections such as rough edges or tabs, small repair spots etc.. which are ‘sandable’ Read more here>
The part is intended to be finished by the customer: rough sand > filling primer > sand smooth > paint. ASA parts are UV resistant without paint but you still need to paint to get a smooth finish.
It is recommended to use the same finish on both sides of the part: if you paint the outside, make sure to paint the inside as well, to keep the exposure to humidity symmetrical.